Autodesk posts Hotfixes for Inventor 8

28 Jan, 2004

Autodesk released three hotfixes for Inventor 8 and Inventor Professional 8.

Hotfix TS83065 fixes this problem: When you try to perform Save Copy As DWF on a file that was opened from a read-only folder, Inventor does a quick exit.

Hotfix TS82976 corrects this issue: When you create an AutoCAD Release 12 DXF file from an IDW file, the DXF file is unreadable in AutoCAD Release 12.

Hotfix TS82940 addresses a problem with Undo command in Inventor Professional 8. This command can cause instability when you're working with the Tube and Pipe or Cable and Harness capabilities.

Note that these hotfixes should be installed only on those systems that need them. In the Help menu under About Autodesk Inventor, check to make sure the build number is 072g. If so, download,, and